Installation Guide and Attentions for CENO's ECN Series through hole slip ring

Installation Guide and Attentions for ECN Series through hole slip ring from CENO company

1. Before install the slip ring, comb the wires at both ends of rotor and stator, then put the slip ring inner hole on the rotating shaft, and then use four screws on the rotor end to fix it through the cooperation of the shaft and hole. Before tightening the screws, should turn the slip ring to ensure that the center of the slip ring is concentric with the rotating shaft. Then tighten the screws.

2. The stator end is inserted into the U-shape groove of the anti-rotation tab with the lever, and then comb the lead wire, to avoid twisting between the lead wire and outlet of the surrounding rotor.

3. The slip ring is a precision electrical component, if the operating environment is harsh, should add protective measures, or customize a slip ring with high protection.

Attentions:

1. The slip ring cannot be used to bear the weight of connected equipment, and the wire cannot bear external pulling force too.

2. During the installation, both ends of the slip ring should be set aside for the outlet line, and protect the wire from being scratched, separated from each wires to avoid the interference of the rotation process, to ensure the performance is not affected.

3. Both the rotor and the stator lead wire of the slip ring cannot be tightly connect, one end must be kept tight and the other end should be flexible, otherwise it will affect the service life of the slip ring.

All the screws must be protected from loosening due to vibration or impact, and can not be loosened due to vibration and impact during working.